The ID you scanned is not saved?

Subject: SECUTEST S2N+ and SIII+

You must make the following setting in the bottom paragraph in the switch positions as follows:

In the S2:

• Line
• Passive
• Active
• EDP

For the SIII in the position Auto respectively for the test sequences:

• VDE 0701-0702
• EN62353/VDE0751
• EN60601

Then proceed as follows:

• Select one of these settings and go to SETUP with the down arrow key and then to Database.
• There must be a - at the setting ID no. = test sequence.

and for ID no. = 000

• At Start with ID-No. you can set an X, but you don't have to.
• When going back, save the setting
• Do this also with all other settings, then the ID should be stored correctly.